All posts by: edgetechree

About edgetechree

ASTM B338 Titanium Tube: What Buyers Should Specify Before Ordering

When an engineer requests an ASTM B338 titanium tube, the material grade is only one part of the specification. In practical purchasing, several tubes may all be described as “Grade 2 titanium tubing” while differing significantly in manufacturing route, dimensional tolerance, inspection requirements, surface condition, and suitability for the final equipment. For heat exchangers, condensers […]

Posts

Shape memory alloy bearings

Christopher DellaCorte, a tribology and rotating machinery expert at NASA, was trying to use nickel-titanium alloys to make spherical bearings because traditional ball bearings are prone to rusting and pitting in extreme environments, especially when flying in aerospace. But nickel-titanium alloys are different from traditional bearing steels. Nickel-titanium alloys are made of a combination of […]

Posts

ASTM B365 Guide for Tantalum Wire and Tantalum Rod Buyers

ASTM B365 is one of the most important references a buyer can put on a tantalum wire or tantalum rod purchase order. It does not tell you everything about the material, but it does define a technical baseline that helps prevent expensive misunderstandings. What ASTM B365 Covers The standard covers both unalloyed and alloyed tantalum […]

Posts

Using Molybdenum Sheet and Plate in High-Temperature Furnaces and Glass Processing

If a plant runs thermal equipment long enough, somebody eventually learns the hard way that heat alone is not the full materials problem. Shape retention, thermal cycling, contamination, atmosphere, and maintenance access usually matter just as much. That is exactly why molybdenum sheet and molybdenum plate keep showing up in high-temperature furnaces and glass-processing hardware. […]

Posts

Why Molten Metal Does Not Wet Silicon Nitride Crucible Surfaces

Introduction: A melt can touch a crucible wall for hours and still refuse to spread, and the reason sits in interfacial physics rather than luck. Anyone who has watched aluminum or brass freeze inside a crucible has seen two very different outcomes. Sometimes the metal clings as a thin skin that has to be chipped […]

Posts

High-Temperature Silicon Nitride Substrates for Industrial Power Systems

Introduction: Industrial power systems that combine 1200°C heat, high voltage, thermal cycling, and mechanical vibration need engineered silicon nitride insulation rather than generic refractory ceramics. Sourcing a high-temperature sensor, industrial power module, or aerospace electronic package often starts with a shortlist of refractory ceramic manufacturers and ceramic parts manufacturers. Many suppliers work with refractory ceramics […]

Posts

Why 2025–2026 Tantalum News Matters to Medical Device Engineers

Most materials news is not immediately useful to device engineers. A product launch happens, a platform gets announced, a market report appears, and none of it changes tomorrow’s build. But a few recent developments around tantalum and visibility-related device quality are worth paying attention to because they point in the same direction: materials are no […]

Posts